West Hills Tractor

Information

2024 Diller Ag Cattle Silage Feeder Wagons SFW-7224

The 7200 series cattle feeders are designed primarily for feeding grain, silage or haylage. The 7200 series feeders are 72" wide with a 12" deep pan that can hold a lot of feed.

The feeder body is fabricated from 10 gauge sheet steel with 4 drain holes in each end. The slant bar racks are constructed from heavy duty schedule 40 pipe.

Our 7200 series wagon feeders are available in 12', 16', 20' 24' and 28' lengths. They have an "Easy Hitch" pull out tongue on the dual wheeled front dolly and a rear axle.

The 7200 series cattle feeders are finished to look new and remain rust free for years. After fabrication, the entire feeder is acid washed to remove any oils, dirt or other contaminants that could prevent paint adhesion. A coat of epoxy primer forms the base of the finish and is topped off with a finish layer of PPG™ two-part polyurethane paint. Due to the "elastic" nature of polyurethane paint it provides a durable finish that resists fading, chalking and chipping unlike many other paints or powder coating. (7220 is pictured above)

• 10 Ga. Steel Bottom with Feed Divider and Reinforced Corners

• Sch. 40 Pipe Racks and Basket

• Hay Basket Design Eliminates Waste

• 4 Drain Holes in Both Ends

• 6 Lug 9.5Lx15 Tire & Wheel

• Reinforced Axles

• Easy Hitch - Pull Out Tongue

• Tongue Stores in Upright Position

• Epoxy Primer

• Diller Green or Diller Red Polyurethane Paint